Alvarion BreezeMAX Si 4000 CPE User Manual page 105

Chapter 8 - Displaying Status Details
Item
IP Address
MAC
IP Subnet Mask
IP Default Gateway
IP Default Connection
Firewall
Lease Obtained-Data
Lease Expires-Data
DNS Server
Time Server
Device Up Time
Device Restart Reason
Serving BSID
RSSI
CINR
BreezeMAX Si 4000 CPE
Table 8-1: Device Status Parameters (Continued)
Description
WAN IP address, if the Static connection mode was selected,
as defined in
For DHCP mode - IP address acquired on the WAN interface
is displayed. Otherwise it is 0.0.0.0
WAN MAC Address
The IP subnet mask, if the Static connection mode was
selected, as defined in
page 44
, For DHCP mode - IP Subnet Mask acquired on the
WAN interface is displayed. Otherwise it is 0.0.0.0
The IP Default Gateway, if the Static connection mode was
selected, as defined in
page 44
. For DHCP mode - IP Default Gateway acquired on
the WAN interface is displayed. Otherwise it is 0.0.0.0
IP is connected to the network (On/Off)
Firewall enabled or disabled (on/off), as set in
page 75
.
Date of obtaining the device leasing.
Date of device leasing expiration.
The Domain Name Server address
The NTP (Network Time Protocol) server address
Duration of device function (xdays yhours zminutes)
The reason for last device reboot (e.g. Software Upgrade)
Base Station ID number (e.g. 00:01:21:00:03:5A)
Currently received signal strength indication (e.g. 78 dBm)
Carrier to Interference-plus-Noise Ratio [in decibels (dB)] (e.g.
13 dB). This value should be maximized for best signal quality.
"Setting Basic Parameters" on page 44
"Setting Basic Parameters" on
"Setting Basic Parameters" on
89
Device Status
.
"Firewall" on
User Manual