Brake Fluid - Mitsubishi FUSO FE 2006 Owner's Manual

12-28
Simple inspection and service
5.1 Check
1. Remove inspection plug
the oil is topped off.
2. If insufficient, add oil through the inspection plug
hole until it is full to the brim.
CAUTION
The added oil should be of the same grade and
viscosity as the oil originally placed in the dif-
ferential gears.
Z09245
3. Install the inspection plug.
Tightening
torque
5.2 Replacement
1. Remove inspection plug
let the oil flow out.
WARNING
The gear oil is extremely hot immediately
after the vehicle has been operated. Take
care to avoid being scalded when draining
hot oil. Give the oil time to cool before drain-
ing it.
NOTE:
Oil removal is quicker if performed not so long after
the vehicle has been stopped and while the oil is
still warm.
2. The drain plug is fitted with a magnet. Wipe off
any metal particles sticking to the magnet and
install the drain plug.
Tightening
torque
3. Add oil through the inspection plug hole until it
reaches the bottom of the hole.
4. Install the inspection plug.
Tightening
torque

6 Brake fluid

Inspection
intervals
Replacement
intervals
Have the brake fluid replacement performed by an
authorized dealer.
and make sure that
98 to 115 N·m (72 to 87 ft.lbs.,
10 to 12 kgf·m)
and drain plug
98 to 115 N·m (72 to 87 ft.lbs.,
10 to 12 kgf·m)
98 to 115 N·m (72 to 87 ft.lbs.,
10 to 12 kgf·m)
At the time of pre-operational
check
Every 50,000 km (30,000 miles)
or every 24 month
to