System Menu - Panasonic aj-spd850p Operating Instructions Manual

Setup menus (continued)

SYSTEM menu

No./Item
Coarse adjustment of system phase: 90 ° units
11
SYS SC COAR.
0000
0001 90
0002 180
0003 270
Fine adjustment of system phase:
12
Variable range ±45 ° or more
–: Advanced, +: Delayed
SYS SC FINE
0000 –128
:
0128
:
0255 127
System phase adjustment: 74 ns steps
13
–: Advanced, +: Delayed
SYS H
0000 –128
:
0128
:
0216 127
SCH phase adjustment: 90 ° units
14
(The SC phase changes but the H phase does not change.)
–: Advanced, +: Delayed
SCH COARSE
0000
0001 90
0002 180
0003 270
SCH phase adjustment:
15
Total variable range: ±45 ° or more
(The SC phase changes but the H phase
SCH FINE
does not change.)
–: Advanced, +: Delayed
0000 –32
:
0032
:
0064
The underlined items indicates the initial setting.
Video output signal adjustments
The video output signal adjustments are made by using the ENC CONTROL switch on the front panel and selecting the
SYSTEM menu item No. 19 (SYS SC/H) settings. A control matrix of the adjustments is shown below.
Setting
ENC CONTROL SYSTEM menu item
19: SYS SC/H
LOCAL LOCAL
REMOTE
REMOTE LOCAL
REMOTE
Description
Note:
0
If setting operation is
performed, the setting
value does not return to
factory (default) setting.
Note:
If setting operation is
:
performed, the setting
0
value does not return to
:
factory (default) setting.
Note:
If setting operation is
:
performed, the setting
0
value does not return to
:
factory (default) setting.
0
:
0
:
32
SYSTEM menu item
11: SYS SC COAR.
12: SYS SC FINE
13: SYS H
The memory card recorder
The memory card recorder
External encoder remote controller
No./Item
This adjusts the audio output phase
16
with respect to the video output:
20.8 µs steps
AV PHASE
–: The audio output phase is advanced
+: The audio output phase is delayed
0000 –100
0100
0200
18 System phase adjustment.
SYS H OFFSET 0000
0001
0002
0003
0004
0005
0006
Note:
If setting operation is performed, the
setting value does not return to factory
(default) setting.
19 This sets whether the system phase is
to be adjusted by the memory card
SYS SC/H recorder or from the external encoder
remote controller.
0000 REMOTE :
0001
Note:
This setting does not take effect when
LOCAL has been selected by the ENC
CONTROL switch on the front panel.
Item adjusted
Front panel (under section)
VIDEO LEVEL
CHROMA LEVEL
SET UP/BLACK
HUE/CHROMA PHASE
The memory card recorder
External encoder remote controller
– 37 –
Description
with respect to the video output.
with respect to the video output.
: :
0
: :
100
–3 : –13.4 µsec
–2 : –8.96 µsec
–1 : –4.52 µsec
0 : 0 sec
1 : +4.52 µsec
2 : +8.96 µsec
3 : +13.4 µsec
The system phase is adjusted from
the external encoder
controller.
LOCAL :
The system phase is adjusted by the
memory card recorder.
remote