Touch Panel Controller (Tpc) - Christie CP4220 User Manual

8.7

Touch Panel Controller (TPC)

• If the TPC does not appear, restart the projector.
• If the TPC display is blank, ensure the TPC is on by opening the flap at the back of the TPC and verify the
grey button in the bottom left corner is ON.
• If the button taps on are misinterpreted, the TPC screen may need recalibrating. Tap Menu > Administrator
Setup > Preferences. Tap Calibrate Screen and follow the instructions on the screen.
8.8 Trouble Establishing Communication with Projector
Verify all input devices have the same subnet mask and unique IP addresses.
1. From the Desktop Launcher, Administrator Setup: Communication Configuration menu, check the IP
Address and Management IP address with the Subnet Mask address. Ensure these belong to the same
network.
8.9 Blank Screen, No Display of Cinema Image
• Ensure the lens cap is not on either end of the lens.
• Ensure the lamp is ON.
• Confirm all power connections are OK.
• Ensure the douser is OPEN by verifying the state of the douser on Main panel as well as the state of the
douser switch at the back of the projector in the top, left corner.
• Ensure any test pattern other than the full black test pattern displays properly.
• Verify the correct display file is selected?
• For cinema connections, verify the correct port is used.
8.10 Severe Motion Artifacts
Verify if there is a synchronization problem with reversed 3-2 pull-down in the 60Hz-to-24Hz film-to digital
conversion and correct it at the source.
8.11 Image Appears Vertically Stretched or 'Squeezed' into Center of Screen
To regain full image width and proper proportions you may need to install an anamorphic lens. Open the
Source File Setup window and verify the resolution and aspect ratio settings. Open the Screen File Setup
window and verify the lens factor settings.
8.12 No Image, Just Pink Snow
This problem occurs when the correct cryptographic key is not available to decode encrypted cinema content..
• If the projector security lid is unlocked or open, a warning appears on the Touch Panel Controller (TPC).
Pause or stop the show on the server and then close and lock the lid. Press Play on the server and wait for the
projector to receive the decryption keys from the server. If the projector does not recover after 30 seconds,
pause or stop the show and try pressing Play again. If this solution does not work, reset the server. Check the
Status window on the TPC for a tamper warning. If the lamp door is closed, the tamper switch may be faulty.
CP4220 User Manual
020-100690-02 Rev. 1 (01-2012)
Section 8: Troubleshooting
8-3