Ac / Power Precautions; Lamp Precautions - Christie CP4220 User Manual

Section 1: Introduction
1.2

AC / Power Precautions

To correctly install this projector, a certified electrician must install a permanent a single-phase connection
from the projector to the AC supply. You must operate the projector at the recommended voltage.
WARNING
Disconnect projector from AC before opening any enclosure.
1) DO NOT allow anything to rest on the power cord. Locate the projector where the cord
cannot be damaged by people walking on it or by objects rolling over it. Never operate the
projector if the power cable appears damaged in any way.
2) DO NOT overload power outlets and extension cords as this can result in fire or shock
hazards.
3) Note that only qualified service technicians are permitted to open any enclosure on the
product and only if the AC has been fully disconnected from the product.
Power Cords and Attachments
WARNING
that you are using a power cord, socket and power plug that meets the appropriate local
rating standards. 2) Use only an AC power cord recommended by Christie. Do not attempt
operation if the AC supply and cord are not within the specified voltage and power range.
Use only the attachments and/or accessories recommended by Christie. Use of others may result in the risk of
fire, shock or personal injury.
1.3

Lamp Precautions

Lamps used in the projector are under high pressure and you must handle them with caution. Lamps can
explode and cause serious personal injury if they are dropped or mishandled.
DANGER
door is open.
Recommended protective clothing includes, but may not be limited to a polycarbonate face shield,
protective gloves, and a quilted ballistic nylon jacket or a welder's jacket. This equipment is included in
included in the Christie Protective Clothing Safety Kit #598900-095.
NOTE: Christie's protective clothing recommendations are subject to change. Any local or federal specifica-
tions take precedence over Christie recommendations.
DANGER
whenever the lamp door is open or while handling lamp. 2) Ensure those within the vicinity of the
projector are also equipped with protective clothing. 3) Never attempt to access the lamp while the
1-2
1) The North American rated line cord is provided with each projector. Ensure
EXPLOSION HAZARD! Wear authorized protective safety clothing whenever the lamp
Lamp may explode causing bodily harm or death. 1) Always wear protective clothing
CP4220 User Manual
020-100690-02 Rev. 1 (01-2012)