Christie CP4220 User Manual page 165

Measured Color (MCG) (Continued)
Set/Get active MCGD measurement values. The order is RedX, RedY, GreenX, GreenY, BlueX, BlueY,
DATA
WhiteX, WhiteY, BlackX, BlackY. The range for each value is 0 - 100000. The values represent MCGD
measurement values multiplied by 100000.
Saves the active MCGD measurement values to a new or existing MCGD file. (SET Only Command)
SAVE
EXAMPLES:
(MCG+C108 "Nominal") Use file "Nominal" on channel 108
(MCG+C108?) Get measured color file name on channel 108
(MCG?L) List all entries of measured color control
(MCG+DATA 123 31786 00333 0 100000 66000 1 88899 2154 5441) Set the active MCGD measurement values to
RedX=0.00123,
RedY=0.31786, GreenX=0.00333, GreenY=0.00000, BlueX=1.00000, BlueY= 0.66000, WhiteX=0.00001, WhiteY=0.88899,
BlackX=0.02154, BlackY=0.05441
(MCG+DATA?) Retrieve the 10 active MCGD measurement values.
(MCG+SAVE "filename") Save the 10 active MCGD measurement values to a file named "filename". If the file doesn't exist, it
will be created. If the file already exists, it will be overwritten.
Monitor Card Cage Fans (MCF)
Enables or disables the monitoring of the two additional card cage fans.
SUBCODE DESCRIPTION OF USE
Set to 1 to monitor and 0 to not monitor.
NONE
EXAMPLES:
(MCF 1) Start monitoring the card cage fans
Channel Name (NAM)
Set the descriptive channel name for the specified channel
SUBCODE DESCRIPTION OF USE
Replace xxx with the channel number. Valid range is 101 - 164.
Cxxx
Select channel name for the current channel.
NONE
EXAMPLES:
(NAM+C108 "Scope 2.39") Set channel name for channel 108
(NAM+C108?) Get channel name for channel 108
Network Setup (NET)
Set the network parameters for Eth0, Gateway, and Subnet 0.
SUBCODE DESCRIPTION OF USE
Set the IP address for the MGMT Ethernet controller (deprecated).
DLP0
Set the WAN IP address for the projector
ETH0
Set the WAN Gateway for the projector
GATE
Host name
HOST
CP4220 User Manual
020-100690-02 Rev. 1 (01-2012)
Appendix B: Serial API
B-17