Printing A Test Label - Monarch 9403 Operator's Handbook Manual

7. Place the roll of supplies on the supply platter so the black
marks pass the sensor.
8. Feed the supply through the supply sensor and slightly past
the printhead.
9. Slide the supply guide down the supply guide roller until it just
touches the edge of the supply strip.
10. Turn the printhead lever clockwise to close the printhead.
P r i n t i n g a Te s t L a b e l
Print a test label to see if your supply is loaded properly.
1. Turn the printer on. You will see
2-4 Loading Supplies
Printhead
PRINT MODE
Ready
Supply
Guide
Supply
Sensor
Supply
Roll