Table of Contents
Advertisement
4. Drop the new supply roll into the supply well until it rests
on the back wall.
5. With thumb and forefinger, insert the leading edge of the
supply into the supply guide until the printer begins to feed
the supply. Make sure the supply roll is flush against the
back wall when you begin to insert the leading edge.
6. Replace the supply holder.
To manually load supplies with the printer turned off, you must
n
insert the leading edge of supply into the supply guide and
then turn the printhead knob clockwise. This will manually feed
the supply through.
Chapter 2. Loading Supplies
Supply
Guide
Knob
Leading
Edge of
Supply
Supply
Well
2-7
Advertisement
Table of Contents
