Apply The Decals - Seagull Models YAK 52 Assembly Manual

APPLY THE DECALS.

1) If all the decals are precut and ready to
stick. Please be certain the model is clean and
free from oily fingerprints and dust. Position
decal on the model where desired, using the
photos on the box and aid in their location.
2) If all the decals are not precut, please use
scissors or a sharp hobby knife to cut the
decals from the sheet. Please be certain the
model is clean and free from oily fingerprints
and dust. Position decal on the model where
desired, using the photos on the box and aid
in their location.
INSTALLING ANTENNA AND THE
BATTERY-RECEIVER.
1) Plug the five servo leads and the switch
lead into the receiver. Plug the battery pack
lead into the switch also.
2) Wrap the receiver and battery pack in
the protective foam rubber to protect them
from vibration.
3) Route the antenna in the antenna tube
inside the fuselage and secure it to the bot-
tom of fuselage using a plastic tape.
Receiver.
4) The last detail is to install the antenna
onto the fuselage. Use a hobby knife to cut a
slot in the top of the fuselage for the antenna.
www.seagullmodels.com
Remove covering
to see hole.
5) Tighten the antenna to the fuselage.
The antenna is removeable so you can install
it at the flying field to prevent damage in trans-
porting.
Tighten the antenna.
C
C/A glue.
C
33