Table of Contents
Advertisement
Preparations
Connecting Peripheral Devices
Connection Example 1: Live Recording / Playout System
32
Connecting Peripheral Devices
This section provides examples of how to connect peripheral devices.
After connecting a peripheral device to the switcher, use the menu system to
make basic settings.
Notes
• When you connect a device that does not allow input of external sync signals,
you can achieve synchronization by enabling the frame synchronizer of the
input connector to which you have connected that device. For more
information about how to enable frame synchronizers, see "Using the internal
frame synchronizers" (page 78).
• The switcher has two REF IN connectors. When you are using a reference
sync signal generator, and do not want to perform loop-through output of the
reference sync signal input to one of the REF IN connectors of the switcher,
attach a 75 Ω terminator to the other connector (see page 28). Also, use 75 Ω
termination on all devices connected to the switcher. The method for
connecting the termination depends on the connected device and the
connection conditions. For details, refer to the operating instructions of the
connected devices.
The figure below shows an example of a system configured with this switcher,
several video cameras, and video output devices for the addition of special
effects.
Connect the SDI output of the output devices to the SDI IN connectors of the
switcher.
3
Chapter
Advertisement
Table of Contents
