Table of Contents
Advertisement
Specifying the signal type of analog output signals
1
When using the BKDF-901: Press the AUX button.
When using the BKDF-902: Among the AUX03 to AUX10 buttons, press
the button that selects the AUX output that you want to set.
The Aux (AUX output assignment settings) sub menu appears in the display
panel.
2
Press the H button in the numeric keypad until the Output (output detailed
settings) sub menu appears.
"Output" appears in the sub menu title display area. If it is already displayed
there, you can skip this step.
3
When using the BKDF-901: Rotate the F1 knob to select the item that
selects the AUX output that you want to set, from among AUX03 to
AUX10.
When using the BKDF-902: Skip to step 4.
Note
AUX1 and AUX2 are not provided with down-converting capability.
4
Rotate the F3 knob to select the conversion mode.
4:3: Output with 4:3 aspect ratio (edge cropped output)
SQ: Output as squeeze video
LB: Output as letterbox video
Off: Do not down-convert
When you are using the optional BKDF-961 2 SD Video Output Board, specify
the signal type of the analog signals that will be output from the board.
For more information about the BKDF-961, see page 30. For information about
how to install it, see page 38.
Note
Regardless of this setting, signals output from the COMP connector of the
BKDF-961 are always SD analog composite signals.
91
Basic Switcher Settings
Advertisement
Table of Contents
