Table of Contents
Advertisement
44
Installing Optional Expansion Boards
Expansion board
BKDF-910
BKDF-911
BKDF-960
BKDF-961
BKDF-912
BKDF-962
Note
For the BKDF-912 and BKDF-962, use a nut driver to tighten the hexagon
head bolt.
2Using the two screws removed in step 3, secure the connector name plate
to the expansion board installation tray.
Note
Set the tightening torque to 0.49 N·m for step 6-2.
(For BKDF-910)
7
Insert the expansion board installation tray into its original slot, and align
the notches of the levers on both sides of the tray to the left and right sides
of the slot mouth.
8
As shown in the figure below, lock the tray by pulling the tray levers toward
the inside.
The tray is pushed all the way into the slot and locked in place.
Screws
+M2.6 × 4
Hexagon head bolt
(5mm in width across flats) × 4
Tightening torque
0.49N·m
0.5N·m
Advertisement
Table of Contents
