Regulatory And Certification; Fcc Compliance Statement; Labeling Requirements - Logic Instrument Fieldbook I1 User Manual

3 Regulatory and Certification

3.1 FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in
residential area is likely to cause harmful interference in which case the user will be required to correct the interference at
his own expense.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
•
Consult the dealer or an experienced radio / TV technician for help
•
Any changes or modifications not expressly approved by the grantee of this device could
void the user's authority to operate the equipment.
This device is operation in 5.15 – 5.25GHz frequency range, then restricted in indoor use
only, Outdoor operations in the 5.15 – 5.25GHz is prohibit.
This device is slave equipment; the device is not radar detection and not ad-hoc operation in the DFS
band.

3.2 Labeling Requirements

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
3.3 RF Exposure Information (SAR)
This device meets the government's requirements for exposure to radio waves. This device is designed and
manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal
Communications Commission of the U.S. Government.
The exposure standard employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit
set by the FCC is 1.6 W/kg. Tests for SAR are conducted using standard operating positions accepted by the FCC with
the EUT transmitting at the specified power level in different channels.
The highest SAR value for the device as reported to the FCC is 0.57 W/kg when placed next to the body.
3.4 R&TTE
This device complies with the essential requirements of the R&TTE Directive 1999/5/EC.
a
5