Table of Contents
Advertisement
CPU Clock Select Jumper: JP3
Use the jumper "JP3" to select the CPU Clock. If you are installing a CPU that has a 133 MHz CPU
clock, you also have to set the "FSB Frequency" to 133 MHz in the BIOS Setup Utility.
JP3
CPU Clock
100
NC
1-2 short
133/ 166/ 200
(Short means to cover two pins on
a jumper using a jumper cap.)
Clear CMOS Jumper: JP1
The "Clear CMOS" jumper is used when you cannot boot your system due to some CMOS
configuration problem such as a forgotten password. This jumper allows you to reset the CMOS
configurations, and then reconfigure.
Pin1-2 short
Normal (default)
Pin2-3 short
Clear CMOS data
(Short means to cover two pins on
a jumper using a jumper cap.)
The following procedures are for resetting the BIOS password. It is
important to follow these instructions closely.
1.
Turn off your system and disconnect the AC power cable.
2.
Set JP1 to OFF (2-3 Closed).
3.
Wait several seconds.
4.
Set JP1 to ON (1-2 closed).
5.
Connect the AC power cable and turn on your system.
6.
Reset your desired password or clear CMOS data.
2 1
JP3
1
2
3
JP1
1
2
3
JP1
18
KX18D Series
Hide quick links:
Advertisement
Table of Contents
