Handlebar Controls, Right Side - Benelli TnT1130 Use And Maintenance

3.4

Handlebar controls, right side

Front brake lever
Pull to the lever to apply the front brake.
Engine stop switch
It is used to switch off the engine in an emergency. The ignition circuit is disabled, preventing the engine from being
restarted. To be able to restart the engine, return the switch to the "ON" position.
Under normal conditions, do not use this switch to shut off the engine.
Front brake lever
It controls a hydraulic circuit that operates the front wheel braking system.
Throttle twist grip
It controls the fuel-air mixture supplied to the engine, which regulates engine speed. To increase engine speed,
rotate the hand grip from its idle position counterclockwise.
Engine start button
This device permits the motor starting, pushing the steering clutch , if it is used 3 seconds after the motor starting,
you can use the display functions.
To avoid damaging the electrical equipment, be sure not to hold down the button for longer than
5 consecutive seconds.
If, after some attempts, the engine does not start, contact your authorized Benelli service center.
Engine stop switch
Stops the engine and prevents it from being restarted.
Throttle twist grip
Rotate counterclockwise to increase
engine speed.
Engine start button
The push button must be released as soon as the motor
is switched on.
Pressing the button 3 seconds after the motor starting,
you can use the display functions.
19
20