Benelli TnT1130 Use And Maintenance page 17

4.3 Running-in
Failure to observe the indications provided below can reduce performance and shorten the life
of the motorcycle.
Running-in is generally considered to apply only to the engine. In fact, it should be regarded as an essential phase
for other important parts such as the tyres, the brakes and the drive chain. During the very first miles, adopt a
relaxed riding style.
km
rpm max.
0 to 500 Km
5000 rpm
(0 to 312.5 mi)
7500 rpm
500 to 1000 Km
(312.5 to 625 mi)
1000 to 2500 Km
9000 rpm
(625 to 1562.5 mi)
IIn particular, observe for the first 2500 km (1600 mi) the max revolutions number indicated in the table.
After the running-in period, above 2500 km (1600 mi), the engine is "hot" and can be run to its maximum speed.
4.4 Selecting the display functions
ATTENTION
The display modification or regulation
operations, must be made 3 seconds af-
ter the motor starting.
The display is provided with 3 main functions:
1) "TOTAL"/"TRIP"
2) "CHRONO"/"LAP"
3) "CLOCK"/"TRIP"
To move from the visualisation 1 "Total"/"Trip" to the
visualisation 2 press the "Start" button for more than 2
seconds.
To move from the visualisation 2 "Chrono"/"Lap" to the
visualisation 3 press the "Start" button for more than two
seconds (when the chronometer is switched off).
To switch from function 3 to function 1, keep pressed the
"Start" button for less than two seconds.
New tyres must undergo a proper running-in period to reach their
complete efficiency. Avoid abrupt acceleration, turning and braking
during the first 100 km (62,5 mi). Failure to observe these
prescriptions can lead to the sliding of the wheels and the loss of
control of the vehicle with subsequent risk of accidents
NOTE
(Start>2sec)
(Start>2sec with chronometer off)
(Start<2sec)
29
30