Benelli TnT1130 Use And Maintenance page 28

6 Maintenance
6.1 Tables of scheduled maintenance and checks
WARNING
• Impropriety or lack of recommended maintenance operations can lead to an increase of the
risk of accidents and damage to the motorcycle.
• Always use genuine Benelli spare parts. Using non-genuine spare parts can accelerate the
wear of your motorcycle and shorten its life.
• Failure to perform the recommended operations, as well as using non-genuine spare parts,
can cause the unoperativeness of the legal guaranty.
To replace or top up the lubricants and fluids of your motorcycle, use only the suitable products.
PROTECT THE ENVIRONMENT
Benelli, in order to protect the interests of the community, awakens the Customers and the
Technical Assistance operators to use the vehicle and dispose of its replaced parts respecting
the laws in force concerning environmental pollution and waste disposal and recycling.
The main periodic checks and maintenance operations are shown in the following tables. These operations are
necessary to keep the motorcycle safe and in perfect running order.
The intervals indicated in the periodic maintenance and lubrication tables must be intended as a general guide
under normal riding conditions. It could be necessary to reduce these intervals according to the climate, the ground
conditions, the geographic position and the conditions of use.
Some of the operations can be carried out by the user, providing he or she possesses the requisite skills and,
however, only when explicitly scheduled in this Owner's Manual. In any other case have the operations performed
by a Benelli Authorized Workshop, whose list is available on the web site www.benelli.com or calling the Benelli
Coustomer Service dialling 800342300.
As a rule maintenance operations must be performed while the motorcycle is on the rear stand
after switching off the engine and setting the start switch to OFF. On the contrary, while checking
the fluid levels it is advisable to keep the motorcycle in an upright position without using the
rear stand.
Tables of scheduled maintenance
NOTE: the table below describes all the scheduled maintenance operations. The column "COMPETENCE"
indicates (C) who must carry out the operations described:
Legend:
"i" = inspection and adjustment, cleaning, lubrication or replacement according to requirements
"R" = replacement
"T" = tighten
"O" = authorized dealer or personnel
"U" = user
51
52