Right Handlebar Switch - Benelli TnT302S Owner's Manual

PRIMARY PARTS
RIGHT HANDLEBAR
1. ENGINE STOP SWITCH
When the switch is in "
When the switch is in "
TIP：
Under normal conditions, this switch shall be on "Operate" (
position. Use this switch for emergency situations, for example accident or
key switch problems.
2. HAZARD SWITCH"
Turn to " " and the four direction signal lamps would ash to warn for emergency
situation; turn to "●" for daytime riding.
3. ELECTRIC STARTER BUTTON
Pull the clutch lever in or put the transmission in Neutral gear and press the button
to run the electric starter and start the engine.
4. LIGHT SWITCH (IF EQUIPPED)
Turn switch to position of "
up meter lamp, city light and tail lamp; turn to "●" for daytime driving.
5. METER FUNCTION BUTTON
In ODO mode, turn o the key. To adjust the clock, turn on the ignition switch and immediately
long press the set button, when released, the hour digit will start ashing on the meter.
Short press the set button to change the number, or long-press to move the ashing digit
" position and the power is on, the engine runs.
" position and the power is o , the engine will not run.
"
" to light up the front lamp; turn to "
Without Headlight Switch
)
" to light
21
or
With Headlight Switch
TnT302S
1
5
2
3
1
5
4
3