Benelli TnT1130 Use And Maintenance page 35

6.5 Checking the coolant level
Check the coolant level while the engine is off and cold.
The check must be performed after placing the motor-
cycle in an upright position on a horizontal surface.
The level in the cup must be included between the MAX
and MIN references
In the case the cooling liquid level is under the MIN ref-
erence, remove the cup plug and make a topping up, or
bring the motorbike in the closest Benelli authorized
machine shop.
Do not start the engine if the coolant level
is below the MIN mark.
6.5.1 Topping up the coolant level
WARNING
This operation has to be performed only by a Benelli Authorized Workshop. Perform the topping
up of the coolant when the engine is off and cold. Never attempt to remove the coolant filler cap
when the engine is hot, in order to avoid the risk of burns. The cooling system is under pressure!
Under certain conditions, ethylene glycol contained in the coolant can become flammable.
When it is lighted, it produces an invisible flame.
Avoid spilling coolant on hot parts of the motorcycle, because the subsequent combustion of
ethylene glycol could cause serious burns.
Coolant is a highly toxic fluid. Avoid contact and ingestion. Keep coolant out of reach of children
and domestic animals. In the event of a coolant ingestion, immediately call a doctor and do not
cause vomiting, in order to avoid inhalation of coolant in lungs. If the coolant comes in touch
with your skin or eyes, immediately wash it away with water.
Coolant sight glass
65
66