Configure Pop3 Server - D-Link DWC-2000 User Manual

Section 6 - Securing Your Network
Path: Security > Authentication > External Auth Server > POP3 Server
POP3 is an application layer protocol most commonly used for e-mail over a TCP/IP connection. The authentication
server can be used with SSL encryption over port 995 to send encrypted traffic to the POP3 server. The POP3
server's certificate is verified by a user-uploaded CA certificate. If SSL encryption is not used, port 110 will be used
for the POP3 authentication traffic.
The wireless controller acts only as a POP3 client to authenticate a user by contacting an external POP3 server.
This authentication option is available for IPsec, PPTP/L2TP Server and Captive Portal users. Note that POP3 for
PPTP / L2TP servers is supported only with PAP and not with CHAP / MSCHAP / MSCHAPv2 encryption.
To configure POP3 Server:
1. Go to Security > Authentication > External Auth Server > POP3 Server tab.
2. Complete the fields in the table below and click Save.
Field
Authentication Server
Authentication Port
SSL Enable
CA File
Timeout
Retries
D-Link DWC-2000 User Manual

Configure POP3 Server

IP address of the POP3 authentication server.
RADIUS authentication server port to send POP3 messages.
Enable SSL support for POP3. If this option is enabled, it is mandatory to select a
certificate authority for it.
Certificate Authority to verify POP3 server's certificate.
Set the amount of time in seconds, the controller should wait for a response from
the POP3 server.
This determines the number of tries the controller will make to the POP3 server
before giving up.
Description
188