Table of Contents
Advertisement
IDE Primary / Secondary /Master / Sla
Ultra DMA/100 functionality can be implemented if it is
sy
stem. As well, your operating environment requires a DMA driver (Windows 95 OSR2 or a third
p
arty IDE bus master driver). If your hard drive and your system software both support Ultra
D
MA/100, select "Auto" to enable BIOS support. Options: Auto (default)、Disabled
*
**OnChip Serial ATA Setting***
O
n-Chip Serial ATA
T
his item allows you to select the "On-chip Serial ATA" operating mode.
(N
ote: You must use the "Combined Mode" if you have a Windows 98/Me operating system and you
w
ant to install SATA devices).
O
ptions: Disabled (default) Disable on-chip serial ATA
Auto
Combined Mode
Enhanced Mode
SATA Only
S
erial ATA Port0/ 1 Mode
This field determines the operating mode of the SATA
"On-Chip Serial ATA" field.
On-Chip Serial ATA – Combined Mode:
When you set the "On-Chip Serial ATA" to "Combined Mode", you must select one of the PATA
channels to use with the SATA devices. The PATA channel that you use must NOT be currently in
use by another disk device.
Options: Primary Master, Primary Slave, Secondary Master, Seco
On-Chip Serial ATA – Enhanced Mode:
When you set the "On-Chip Serial ATA" to "Enhanced Mode", you must determine which of the
SATA devices will be the master SATA device. You configure this with the "Serial ATA Port 0
Mode" field only.
Options: SATA0 master, SATA1 master
BIOS will auto-detect the presence of SATA devices.
Allows SATA devices attached to this board to simulate a PATA
device by using one of the PATA channels. This mode is necessary if
you have a Windows 98/Me operating system and you want to use
SA
TA devices. Windows 98/Me supports PATA devices but does not
su
pport SATA devices directly.
When you use this mode, you must specify which PATA channels to
use with your SATA devices (see "Seria
"Serial ATA Port1 Mode" fields).
This m
ode allows you to use all of the PATA and SATA connectors
avail
ab
le. If you select this option, you must configure one of the
SATA
channels as the master SATA device (see "Serial ATA Port 0
Mode").
Use the SATA devices only
30
PX865PEL-800
ve UDMA
supported by the IDE hard drives in your
l ATA Port0 Mode" and
ports. The options are determined by the
ndary Slave
Advertisement
Table of Contents
