Table of Contents
Advertisement
IRQ Resources
When resources are controlled manually, you can assign each system interrupt a type, depending on
the type of device using the interrupt. This is only configurable when "Resources Controlled By" is
se
t to "Manual".
Options: IRQ-3/ 4/ 5/ 7/ 9/ 10/ 11/ 12
PCI / VGA Palette Snoop
S
ome graphic controllers that are not VGA compatible take the output from a VGA controller and
map it to their display as a way to provide
Options: Disabled (default)、Enabled
PCI Latency Timer (CLK)
T
his item allows you to set up the PCI Latency Time (0-255). If you select the "32" it will optimize
PCI speeds. Options: 0-255、32 (def
PCI SLOT1- 5
T
his item allows you to select an IRQ address for your PCI slot 1-5.
Options: Auto (default)、3、4、5、7、
Frequency/Voltage Control
CPU Host Frequency (MHz)
This item displays the CPU Host Frequenc
th
e CPU which has the CPU clock is 200 MHz.). The minimum setting is determined by the CPU
that you have installed.
CPU Clock Ratio 8X
When you enable this field, the CPU clock ratio is fixed at "8X" and overrides the entry for the "CPU
Clock Ratio" field (see "CPU Clock Ratio" f
th
e CPU clock speed (CPU clock speed = CPU clock ratio * CPU Host Frequency). It has been
shown that a higher "CPU Host Frequenc
calculating a desired CPU clock speed. T
than usual value (8X), allowing you to use higher "CPU Host Frequency" values.
When you disable this field, the CPU clock ratio will be determined by the "CPU Clock Ratio" field.
This item will only appear when the CPU clock ratio is not locked by the CPU
O
ptions: Enabled, Disabled (default)
/ 14/ 15
assigned to
boot information and VGA compatibility.
ault)
9、10、11、12、14、15
y. You can set this field to a maximum of 255 (or 550 with
ield). The CPU clock ratio is used, in part, to determine
y" and a lower "CPU Clock Ratio" is more desirable when
his field allows you to set the CPU clock ratio to a lower
26
PX865PEL-800
PCI device
manufacturer.
Advertisement
Table of Contents
