Method of Field Set
2. Method of Field Set
2.1
Field Setting
Wired Remote Controller
Notes:
(Field setting must be made from the remote controller in accordance with the installation
conditions.)
"
"
Procedure
1. Press the "
2. Press the "
3. If the unit is under group control, it is unified set (factory set).However, if setting on each
4. Press the "
5. Press the "
6. Press the "
7. Press the "
212
Setting can be made by changing the "Mode number", "FIRST CODE NO.", and "SECOND
CODE NO.".
Refer to the following procedures for Field setting.
" button for 4 seconds or more on normal mode to change to "FIELD
SETTING MODE"
" button and choose the desired "MODE NO.".
indoor unit bases or confirming after the setting, use the MODE NO. in the ( ) for the setting.
Under group control, press the "
setting to set on each indoor unit bases.
(Unnecessary at unified setting of group control and the UNIT NO. is not displayed)
" upper part of the button and select the "FIRST CODE NO.".
" lower part of the button and select the "SECOND CODE NO.".
" button once to FIX the change of the setting.
" button for about one second and return to the "NORMAL MODE"
" button and select the indoor unit no. that you are
Si18-201
Operating Test