Twin Needle Options - Viking Designer EPIC User Manual

• Upper thread is cut automatically at the start of a jump
stitch.
• Cut commands in designs, stitches or programs.
Designs marked with this symbol are
programmed for automatic jump stitch trim.
Jump stitch trim commands can be added to
any design using the complimentary software
(PC).
Tip: Hold the thread tail when you start embroidering or at a new color
block so that you can easily remove the thread end when cut.
Tip: If the front and back of your embroidery will be visible, turn off the
automatic jump stitch trim and cut the threads manually.
Tip: If your designs are very close together, e.g. lettering or programmed
stitches, turn off the automatic jump stitch trim and cut the thread
manually.

Twin Needle Options

When a twin needle size is selected the deLuxe™ Stitch System will automatically use thread tension. When embroidering with a
twin needle the Straight Stitch Plate needs to be removed as it cannot be used together with a twin needle. The twin needle
setting will automatically be set when loading a twin needle embroidery project from the JoyOS advisor™ project menu.
Note: It is very important to activate the twin needle setting when embroidering with a twin needle to prevent damage to the machine.
164 11 Settings