Inserting The Bobbin; Changing The Presser Foot - Viking Designer EPIC User Manual

Inserting the Bobbin

Use only the bobbins designed for your DESIGNER
EPIC™ machine.
1. Open the bobbin cover by pushing the release button (A)
to the right. Remove the cover.
2. Place the bobbin in the bobbin case. It drops in only one
way with the logo facing up. The bobbin will then rotate
counterclockwise when you pull the thread.
3. Place your finger on the bobbin to keep it from turning
as you pull the thread firmly to the right and then to the
left into the tension spring (B) until it "clicks" into place.
Continue threading around (C) and to the right of the
thread cutter (D).
4. Replace the bobbin cover. Pull the thread to the left to
cut.

Changing the Presser Foot

1. Make sure that the needle is in the highest position. Pull
the presser foot down and towards you.
2. Line up the cross pin on the foot with the gap in the
presser foot ankle. Push the foot into the gap until the
foot snaps into place.
2 Preparations 43