Viking Designer EPIC User Manual page 42

5. Bring the thread directly through bobbin winding thread
guide (C).
Note: Bypass the tension disc when winding through the needle.
6. Place the bobbin on the bobbin spindle on the lower
right side of the machine. The bobbin only fits on one
way, with the logo facing out.
The bobbins included are designed especially for your
DESIGNER EPIC™ machine. Do not use
bobbins from other machine models.
Wind a few turns of thread clockwise around the
bobbin and cut excess thread with the thread cutter (B).
7. Push the bobbin winding lever (A) towards the bobbin.
A pop-up appears on screen. To adjust winding speed
drag the slider. Stop and start the bobbin winding with
the button in the pop-up.
8. When the bobbin is full, the bobbin winding lever will
move back and the winding will stop automatically. The
pop-up message closes. Remove the bobbin and cut the
thread using the bobbin winding thread cutter (B).
Note: If you experience difficulty winding a bobbin through the needle
and you are using a large thread cone, move the cone to the auxiliary
spool pin and use the right clip on the telescopic thread guide instead.
Place the large spool holder with the flat side up and a cone holder on
the auxiliary spool pin before adding the thread cone.
42 2 Preparations