Connect The Embroidery Unit; Remove The Embroidery Unit - Viking Designer EPIC User Manual

Connect the Embroidery Unit

1. Slide the accessory tray off.
2. Slide the embroidery unit onto the free arm of the
machine until it plugs firmly into the socket at the back
of the machine. If needed, use the level adjusting feet so
that the machine and embroidery unit are even. If the
machine is turned off, turn it on.
3. If you were already in embroidery mode or when you
switch to embroidery mode, a pop-up message tells you
to clear the embroidery arm and remove the hoop before
calibration. Touch OK. The machine will calibrate and
the embroidery arm will move to the ready position.
Note: DO NOT calibrate the machine with the embroidery hoop
attached as this can damage the needle, presser foot, hoop and/or the
embroidery unit. Be sure to clear all materials from around the machine
before calibrating so that the embroidery arm does not bump into
anything while calibrating.

Remove the Embroidery Unit

1. To store the embroidery unit in the embroidery case,
move the embroidery arm to park position. See park
position .
2. Press the button at the left, underneath the embroidery
unit (A) and slide the unit to the left to remove it.
3. Store the embroidery unit in the original black styrofoam
packing material, placed in the soft carrying bag.
50 3 Embroidery Preparations