Threading The Upper Thread; Threading For Twin Needle - Viking Interlude 445 User Manual

Threading the Upper Thread

Make sure the presser foot is raised and
the needle is in the up position
Pull the spool pin out. Place the
1
thread on the spool pin and the spool
holder on the spool pin as described.
Push the spool pin back in.
Bring the thread in the direction of
2
the arrow under the thread guide (a)
and over the thread guide (b).
Bring the thread down between the
3
thread tension discs.
Continue threading by drawing the
4
thread from the right into the slot on
the take-up lever.
Thread last guide just above the
5
needle.
The needle is threaded from front to
6
back. The white on the presser foot
ankle makes it easy to see the eye of
the needle.
Place thread under the presser foot
7
and into the thread knife where it is
cut.

Threading for Twin Needle

!
Turn off the main switch.
Insert a twin needle.
1
Use a second thread spool or wind a
2
bobbin with the thread you are going
to use as the second upper thread.
L : Thread the machine and
3
EFT NEEDLE
check to ensure that the thread lies
between the inner thread tension discs,
and inside the last thread guide. Thread
the left needle.
Attach the extra spool pin onto the
4
machine. Place a spool holder under
the thread.
Place the bobbin with the second
5
thread on the spool pin.
4
b
7
3
5
6
Thread the machine
R :
6
IGHT NEEDLE
as before but this thread should lie
between the outer thread tension
discs, outside the lowest thread guide.
Thread right needle.
Learn your Interlude
2
1
a
7