Dual Feed With Changeable Presser Feet - Viking Designer EPIC User Manual

Use the rounded end of the universal tool to loosen and
tighten the screw.
Dual Feed With Changeable Presser
Feet
The Dual Feed Foot with changeable presser feet is designed
to feed layers of fabric and/or batting evenly. It is perfect for
quilting, sewing velvet, stretch fabrics, imitation leathers and
fabrics that need precise pattern matching. Snap on the
Changeable Straight Stitch Foot when using the straight
stitch in the center needle position with a stitch length up to
6mm. Snap on the Changeable Zigzag Foot when selecting
stitches up to 7mm wide and 6mm long.
Note: Look for optional dual feed accessories in the online accessory
user's guide at www.husqvarnaviking.com or at your HUSQVARNA
VIKING® retailer.
Attaching the Dual Feed
1. Using the universal tool, remove the presser foot ankle.
Note: Do not remove the presser foot ankle screw from the universal
tool after unscrewing it. The universal tool is magnetic and will hold
the screw, making it easy to replace and less likely to be lost.
2. Place the dual feed on your machine from the back,
positioning the fork over the needle clamp screw. Then
screw the dual feed onto the presser foot bar with the
presser foot ankle screw.
Snap on and Remove the Presser Foot
3. With presser foot bar in the up position, place the presser
foot under the dual feed.
4. Push the foot upwards so that it snaps into place.
5. To remove the foot, push the front of the foot upwards
until the foot snaps off.
Note: Always keep the dual feed with a foot snapped-on when it is
not attached to the machine.
1. Dual Feed
2. Changeable Zigzag Foot
3. Changeable Straight Stitch Foot
2 Preparations 45