Viking Designer EPIC User Manual page 148

Auto Smart Save
If a power outage has occurred, you will see this pop-up
message when the machine is restarted. Touch OK in the
pop-up to return to embroidery stitch out. This will load the
design ready to stitch from approximately the same position
it was interrupted.
Tip: Before starting the embroidery go back a few stitches using the step
stitch-by-stitch control to ensure that the threads will be secured.
Change Needle (Optional Accessory)
Cutwork designs and felting designs require special optional
needle accessories. Cutwork designs require the
HUSQVARNA VIKING® Embroidery Cutwork Needle Kit
(920268-096) and felting designs require the HUSQVARNA
VIKING® Felting Embroidery Set (920402-096).
When the machine stops and this pop-up message is shown,
insert the corresponding optional needle. Touch OK and
press the start/stop button to resume.
Cutwork designs are marked with a cutwork needle symbol
and felting designs are marked with a felting needle symbol in
the DESIGNER EPIC™ Sampler book.
Note: Cutwork designs can also be stitched out without using the
cutwork needles. The cutwork area will then have to be cut manually
and the color block for the cutwork needle in the color block list should
be skipped.
Attention!
If the machine stops and this pop-up appears on the screen
you cannot continue embroidering. Wait a moment and touch
OK when it is enabled. Check needle size and condition and
check that your machine is threaded correctly.
148 9 Embroidery Stitch Out