Performing A Printer Self Test - Printek FieldPro RT43 Series Operator's Manual

Printer Operation
To perform a self test, press and hold the Paper Feed Button while turning on the printer with the Power Button.
The printer will print a test page with the following information:
Current Printer Emulation Language
6

Performing A Printer Self Test

Firmware Revision
& Release Date
Printer Serial Number
Serial Interface Installed,
Not Selected
Bluetooth Interface
Installed and Selected
Selected
Interface
Settings
MCR Installed
Image Management
Menu Settings
Device Settings
Menu Settings
Advanced
Menu Settings
Current Battery Voltage
Current
Flash Memory
Contents
Print Head Test Pattern
Control Panel Setup Entry Instruction
Note: At the bottom of the test page the
message "Press Feed For Setup
Menu" will be printed. Do not
press any buttons at this time.
After approximately four
seconds, "Setup Not Requested"
will be printed and the printer is
ready for normal use.
The internal setup menus allow
changes to be made to the
printer's interface and printing
features. Improper changes may
make your printer perform poorly
or not at all. These menus should
only be used under the direction
of your technical support staff.
For more information, please
refer to "Appendix A – Printer
Configuration".