Initial Power Up And Self-Test - Printek Mt3 Series Operator's Manual

Initial Power Up And Self-Test

Once the Battery is charged and the paper is loaded perform an initial power up
self-test.
Note: The self-test feature only functions if printer is in the
manual power off mode (factory default). See "Dipswitch
settings"
1. To start the self-test, press and hold the
ON . The printer will start printing the self-test messages.
2. Press the OFF or FEED to stop or cancel the self-test print.
The first few lines of self-test show the printer firmware version, the current
printer settings and a list of any optional or special features installed. Also
sample demo lines are printed using the internal resident printer fonts.
FEED button, then press
9