Download Print this page
Printek I-820 Quick Start Manual

Printek I-820 Quick Start Manual

Advertisement

Quick Links

I-820
This guide provides information on the daily use of the I-820 printer.
For additional information, please refer to the I-820 User Guide.

Printer features

Paper Door
Control Panel
Printer with optional battery: Charging
New batteries are shipped in uncharged state.
Charge using Printek approved external AC or DC
adapter.
DO NOT charge battery via USB port.
Charge for minimum of four hours prior to use.
Approximate battery life of 100 pages.
© 2017 Printek LLC 3515 Lakeshore Drive, St. Joseph, MI 49085 PH:269-925-3200
Quick Start Guide
Paper door release button
Power Port
USB Data Port
www.printek.com | E: info@printek.com
Media(8.5'')
Press Paper door release button to open the paper
compartment door. Pull small leader of paper out and
close paper door. " Clicks" when properly closed.
Printer with optional battery: Replacement
Press button to see
battery charge level.
Remove the two screws to
remove the battery.
Battery Disposal
.
Only dispose of used batteries according to your local regulations. If
you do not know your local regulations, the Rechargeable Battery
Recycling Corporation (RBRC) is a non-profit organization created to
promote recycling of rechargeable batteries. For more information
visit www.call2recycle.org
Tear paper
towards back of
printer
4LED 100% charge
3LED 75%
2LED 50%
1LED 25%

Advertisement

loading

Summary of Contents for Printek I-820

  • Page 1: Printer Features

    I-820 Quick Start Guide This guide provides information on the daily use of the I-820 printer. For additional information, please refer to the I-820 User Guide. Printer features Media(8.5’’) Paper Door Tear paper towards back of printer Paper door release button...
  • Page 2: Control Panel Indicators

    Connect a USB cable between the printer and a PC. To access the I-820 web page, push the Power button twice rapidly. This will put the printer into Configuration mode. When the printer is in Configuration mode the POWER and FAULT LEDs will flash together.
  • Page 3 Once the printer is connected via USB and in IP over USB mode it is temporarily not possible to access the Internet. © 2017 Printek LLC 3515 Lakeshore Drive, St. Joseph, MI 49085 PH:269-925-3200 www.printek.com | E: info@printek.com...