Printek FieldPro RT43 Series Operator's Manual page 47

INTERFACE MENU – Wi-Fi Selected
Menu Item
Emulation Printek, O'Neil, ZPL-II, Mt3, CPCL,
MPL, IPL, ESim, Hex Dump
Pass Through Mode On, Off
SSID
Type Access Point, Ad Hoc
Channel
Encryption WEP 64, WEP 128, WPA, Open
Authentication Open PSK, Shared PSK, PSK, Leap
Auth Protocol PAP, MS-CHAP v2
Use WEP Key #
IP Method
Address
Subnet
Gateway
Printer Server Port
Advanced Features Contact Printek Technical Support
Print Interface Settings
Possible Values: None
Selecting this item will cause the current interface setup item values to be printed for reference.
Note that this item is only available when using Control Panel Setup.
Emulation
Possible Values: Printek*, O'Neil, ZPL-II, Mt3, CPCL
This item sets the family of printer commands that may be used by a host application program to control the
various capabilities of the printer. The printer will only respond to commands valid for the currently selected
emulation. For more information, please refer to the MtP Series & FieldPro Programmer's Manual.
Note: HexDump is a diagnostic mode used to assist software programmers in determining the actual data
values being received by the printer. In this mode, printer commands are not processed, but are
printed along with their hexadecimal value. For more information, please refer to the MtP Series &
FieldPro Programmer's Manual.
Radio Pass-Thru
Possible Values: Off*, On
This item allows direct communication to the Bluetooth or Wi-Fi interface, if installed. When "On", this
feature allows use of a terminal emulation program to access advanced configuration options. Please contact
Printek Technical Support for details.
Appendix D – Using the Wi-Fi Interface
Values
Setup Method
Default Value
Control
Panel
Printek
Off
Any
Ad Hoc
1
Open
Open PSK
PAP
1
DHCP
192.0.0.192
255.255.255.0
192.0.0.1
8023
Setup Web
Utility Page
41