Printer Self-Test - Printek PrintMaster 862 Operator's Manual

3. Feed the paper up through the bottom of the printer with the printed side facing you and position
the holes in the edge of the paper over the pins in the left tractor while making sure that the paper
will not extend above the top of the tractors. Then close the tractor door.
Note:The left tractor position is not adjustable. If it is necessary to adjust where printing begins, refer to
the "
Aligning Print
5. Now position the paper in the right tractor in the same fashion. If necessary, the position of the
right tractor may be adjusted. To do so, move the lever on the side of the tractor down to unlock the
tractor and slide the tractor sideways on the shafts
After the paper is placed in the tractor and the tractor door is closed, position the tractor far enough
to the right so that there is no buckle in the paper between the two tractors, but not so tight that the
holes in the paper are distorted. Lock the tractor in place by returning the lever to the up position.
6. Close the bottom paper door and lower the front of the printer down until it latches in place.
Selecting Which Form to Print
With the printer off line, press the UNLOAD/CHANGE button until the desired form is displayed. To use the
bottom path, the word "Bottom" must appear below the form name. If the desired paper path is not shown,
refer to the " " topic in the "
Tractor Path
chapter. When the desired form and path are displayed, press the LOAD/FEED button. The LOAD/FEED
button will position the form for printing but will not place the printer on line. The ONLINE button will
both position the form and place the printer on line.

Printer Self-Test

The printer performs many self-diagnostics each time power is applied. If you wish to perform an actual
printing test, use the following steps.
" in the " DAILY OPERATION
" section of the "
Forms Menu
G E T T I N G
" section of this manual.
PRINTER CONFIGURATION
S T A R T E D
"
9