Printek FieldPro RT43 Series Operator's Manual page 27

DEVICE SETTINGS
Menu Item
Left Margin
Right Margin
Maximum Paper Speed
Form Feed Control
Form Feed Distance
Top of Form Adjust
Tear Adjust
Mark Sensitivity
Left Margin
Possible Values: 0.0000"* ... 1.0244" in increments of 0.0394"
This item sets the left margin in inches relative to the leftmost printing position. The left margin must be less
than the right margin.
Right Margin
Possible Values: 0.0000"* ... 1.2608" in increments of 0.0394"
This item sets the right margin in inches relative to the rightmost printing position.
Text characters that would have printed to the right of the margin will either be "wrapped around" and printed
on the next line, or will be discarded based on the setting for "Truncate Lines" in the Image Management menu.
Graphic data that would have printed to the right of the margin will be truncated.
Maximum Paper Speed
Possible Values: 0.08, 0.25, 0.49, 0.74. 0.99, 1.24, 1.48, 1.73, 1.98, 2.22, 2.47, 2.72, 2.80* ips
This item may be used to reduce the maximum paper speed if necessary to allow the printer to use heavier paper
or labels, narrow paper or labels, or some coated papers that have a more slippery finish.
Form Feed Control
Possible Values: Front Mark, Distance*
Mark Sensing is used to identify form or label position marking and must be set to match the paper being used.
The use of Black Mark sensing is associated with the design of the application program that is controlling the
printer. For more information on Black Mark sensing, please refer to the MtP Series &FieldPro Programmer's
Manual.
Values
0 to 1.0244"
0 to 1.2608"
0.08 to 2.80 ips
Front Mark, Distance
0.0394 to 2.5216"
-0.2955 to 0.2955"
-0.2955 to 0.3152"
-10 to +10
Appendix A – Printer Configuration
Modify From
Default Value
Control
Panel
0
0
2.80 ips
Distance
1.2608"
0.0000"
0.0000"
0
Setup
Utility
21