Digisol DG-SC8860VPI User Manual page 31

Static IPv4 / IPv6: Assign an IPv4 / IPv6 address to IP camera manually. If you
don't have a DHCP server on your local area network, you must use this option
to specify an IP address.
IP Address(IPv4): Input IPv4 IP address
IP address (IPv6): Input IPv6 IP address
Prefix Length: Input IPv6 IP address prefix length (0-128)
Subnet Mask: Input subnet mask
Gateway: Input gateway address
Primary DNS: Input DNS server's IP address
Secondary DNS: Input backup DNS server's IP address, you can leave this field
blank.
Enable UPnP Discovery: Check this box to enable other devices on the network
to discover the presence of this IP camera by UPnP. It's recommended to enable
this function.
Enable UPnP Port Mapping: When UPnP is enabled, check this box to enable
UPnP's port mapping.
PPPoE Select this option to use PPPoE to connect to network. You have to input PPPoE
username and password assigned by network operator to get connected.
HTTP Port Input IP camera's web connection port number here. When this port number is
changed, you need to change web browser's port number you used to connect to
IP camera.
For example, IP camera's IP address is 192.168.2.3, and if you changed HTTP
port number to 82, please input 'http://192.168.2.3:82' in web browser's address
bar to access IP camera's web configuration interface.
RTSP Port Input RTSP port number. When this port number changes, you must change
corresponding settings in external network devices (NVR or SKYROS software)
so they can receive this IP camera's video.
RTP Data Port Input RTP data port number here.
When you finish with above settings, click 'Apply' button to save changes.
31
DG-SC8860VPI User Manual