Table of Contents
Advertisement
5. Connect all your cables to their respective terminals. Insert your micro SD/SDHC card for
storage option. Please see the location refer to point 9.
6. If this camera is connected to a PoE switch then the device can be powered on without using the
power adapter.
7. Power on the camera again and refer to the following procedures in
configure it.
8. If everything works fine, you can put the camera on the wall or ceiling by using the screws in
the tools package.
9. You can insert the micro SD card in the slot as shown below for local storage.
10. See the above image and find the location of the reset button on the SD card board. Press the
button over 10 seconds to reset the device when needed.
14
DG-SC8860VPI User Manual
section 2
to access and
Advertisement
Table of Contents
