Speakers - HP Elite x2 1011 G1 Maintenance And Service Manual

Speakers

Description
Speakers (include left and right speakers and cables)
Before removing the speakers, follow these steps:
1. Shut down the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and
then shut it down through the operating system.
2. Disconnect all external devices connected to the slate.
3. Disconnect the power from the slate by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the slate.
4. Remove the display panel assembly (see
5. Remove the battery (see
Remove the speakers:
1. Disconnect the speaker cable (1) from the docking connector board.
2. Remove the four Phillips PM1.6×2.5 screws (2) that secure the speakers to the bottom cover.
3. Release the speakers cables from the retention tabs (3) built into the bottom cover.
4. Remove the speakers (4).
Reverse this procedure to install the speakers.
44 Chapter 5 Removal and replacement procedures – slate
Display panel assembly on page
Battery on page 39).
Spare part number
793729-001
35).