HP Elite x2 1011 G1 Maintenance And Service Manual page 63

Description
Equipped with an Intel Core i3 M-5Y10c processor, 4.0-GB of system memory, and the Windows 10 or
Windows 8 Professional operating system
Equipped with an Intel Core i3 M-5Y10c processor, 4.0-GB of system memory, and the Windows 10 or
Windows 8 Standard operating system
Equipped with an Intel Core i3 M-5Y10c processor, 4.0-GB of system memory, and a non-
Windows operating system
Before removing the system board, follow these steps:
1. Shut down the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and
then shut it down through the operating system.
2. Disconnect all external devices connected to the slate.
3. Disconnect the power from the slate by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the slate.
4. Remove the display panel assembly (see
the following components:
a. Battery (see Battery on page
b. WLAN module (see
c. WWAN module (see
d. Fan (see Fan on page
When replacing the system board, be sure that the following components are removed from the defective
system board and installed on the replacement system board:
●
RTC battery (see RTC battery on page
●
Solid-state drive (see
●
Heat sink (see Heat sink on page
●
Rear-facing webcam (see
●
Front-facing webcam (see
Remove the system board:
1. Detach the WLAN antenna transceiver (1) from the bottom cover. (The WLAN antenna transceiver is
attached to the bottom cover with double-sided adhesive.)
2. Remove the Phillips PM1.5×2.3 screw (2) that secures the front-facing webcam to the bottom cover.
3. Release the front-facing webcam (3) from the bottom cover.
Display panel assembly on page
39)
WLAN module on page
WWAN module on page
46)
59)
Solid-state drive on page
62)
Rear-facing webcam on page
Front-facing webcam on page
40)
42)
60)
64)
65)
Spare part number
805068-601
805068-501
805068-001
35), and then remove
System board 53