HP Elite x2 1011 G1 Maintenance And Service Manual page 96

10. Release the ZIF connector (5) to which the connector board cable is attached, and then disconnect
the connector board cable from the keyboard base system board.
11. Remove the two Phillips PM2.0×2.5 broad head screws (1) that secure the keyboard base system board
to the top cover.
12. Remove the two Phillips PM2.0×3.6 screws (2) that secure the power connector cable bracket to
the top cover.
13. Remove the power connector cable bracket (3).
The power connector cable bracket is included in the Keyboard Base Bracket Kit, spare part number
793728-001.
14. Lift the right side of the keyboard base system board (4) until it rests at an angle.
86 Chapter 6 Removal and replacement procedures – Keyboard base