Display Panel Assembly - HP Elite x2 1011 G1 Maintenance And Service Manual

Display panel assembly

Description
11.6-in, TouchScreen, FHD, BV, (1920×1080), IPS, 50% CG, typical brightness 400 nits, eDP 1.3, ultra-
slim with digitizer display panel assembly
11.6-in, TouchScreen, FHD, BV, (1920×1080), IPS, 50% CG, typical brightness 400 nits, eDP 1.3, ultra-
slim without digitizer display panel assembly
11.6-in, TouchScreen, HD, BV, (1366×768), IPS, 50% CG, typical brightness 400 nits, eDP 1.2, ultra-slim
with digitizer display panel assembly
11.6-in, TouchScreen, HD, BV, (1366×768), IPS, 50% CG, typical brightness 400 nits, eDP 1.2, ultra-slim
without digitizer display panel assembly
Back cover
Before removing the disassembling the slate, follow these steps:
1. Turn off the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then
shut it down through the operating system.
2. Disconnect the power from the slate by unplugging the power cord from the slate.
3. Disconnect all external devices from the slate.
Remove the display panel assembly:
1. Place the slate on a flat work surface with the docking connector toward you.
2. Remove the speaker grille (1) that covers the display panel screws.
The speaker grille is available using spare part number 793734-001.
3. Remove the six Phillips PM1.5×8.3 screws (2) and the three Phillips PM1.5×3.5 screws (3) that secure
the display panel assembly to the bottom cover.
CAUTION:
step. There are 2 ribbon cables connecting the display panel assembly to the system board that can be
damaged if too much separation is achieved.
Do not completely separate the display panel assembly from the bottom cover in the next
Spare part number
793736-001
804352-001
793737-001
804351-001
793725-001
Display panel assembly 35