Docking Connector Board Cable - HP Elite x2 1011 G1 Maintenance And Service Manual

3. Remove the WiGig antenna (3) cable and transceiver.
Reverse this procedure to install the WiGig antenna.

Docking connector board cable

NOTE: The docking connector board cable is included in the Slate Cable Kit, spare part number 793721-001.
Before removing the docking connector board cable, follow these steps:
1. Shut down the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and
then shut it down through the operating system.
2. Disconnect all external devices connected to the slate.
3. Disconnect the power from the slate by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the slate.
4. Remove the display panel assembly (see
the following components:
a. Battery (see
b. WLAN module (see
c. WWAN module (see
d. Fan (see
e. Docking connector board (see
f. System board (see
Remove the docking connector board cable:
1. Detach the docking connector board cable (1) from the bottom cover. (The docking connector
board cable is attached to the bottom cover with double-sided adhesive.)
72 Chapter 5 Removal and replacement procedures – slate
Battery on page 39)
WLAN module on page
WWAN module on page
Fan on page 46)
Docking connector board on page
System board on page
Display panel assembly on page
40)
42)
52)
35), and then remove
49)