Speakers - HP Elite x2 1012 G2 Maintenance And Service Manual

Speakers

Description
Speakers
IMPORTANT:
replacement
Before removing the speakers, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Kickstand (select products only) (see
b. Back cover (see
c. Display panel (see
d. Battery (see
e. Hall sensor board (see
f. Kickstand hinges (see
g. Solid-state drive (see
h. WLAN module (see
i. WWAN module (see
j. Webcam (see
k. Microphone board (see
l. Rear webcam (see
m. System board (see
n. POGO connector (see
o. Fan (see
p. Fingerprint reader board (see
Remove the speakers:
1. Lift the right speaker (1), and then left the right speaker (2)r.
Make special note of each screw and screw lock size and location during removal and
Back cover on page
Display panel on page
Battery on page
Hall sensor board on page
Kickstand hinges on page
Solid-state drive on page
WLAN module on page
WWAN or GPS module (select products only) on page
Webcam on page
Microphone board on page
Rear webcam on page
System board on page
POGO connector on page
Fan on page 49)
Kickstand on page
29)
30)
32)
34)
35)
36)
38)
42)
43)
45)
47)
48)
Fingerprint reader board on page
Spare part number
925445-001
26)
40)
51)
Component replacement procedures 53