Appliance Set-Up; Door Assembly - Quadra-Fire Adventure-III Installation Manual

5

Appliance Set-Up

A. Door Assembly
Install New Door
1. Place the hinge pins into the hinge holes on the left side
of the door.
2. Place the door on the front of the appliance, carefully
lining it up with the appliance hinge holes. See Figure
5.1
3. If the door is not level:
BOTTOM RIGHT CORNER LOW: With a hammer, tap
Hinge A outward (away from door opening) and tap Hinge
B inward (toward door opening).
BOTTOM RIGHT CORNER HIGH: Tap Hinge A inward
and Hinge B outward.
NOTE: It is important to move both hinges an equal
distance to ensure the proper operation of the door
latch.
4. Door rope may be stiff, which will make the door hard to
close at first, with time it will break in.
Install New Door Handle
Included in Kit: 1 door handle, 1 key, 2 washers, 1 latch
cam, 1 locknut. See Figure 5.2
Tools Needed: 9/16" wrench
1. Slide door handle through door.
2. Install two washer(s) as shown and install key in groove.
3. Align groove in latch cam with key; slide latch cam over
shaft.
4. Install locknut.
CAUTION! DO NOT OVERTIGHTEN LOCKNUT.
DOOR HANDLE NEEDS TO MOVE SMOOTHLY.
5. Install fiber handle using a clockwise motion until the
fiber handle is snug against the door handle shaft.
18
Quadra-Fire • Adventure-III Installation Manual • 4083-901 • Rev B • 05/15
Hinge Pins
A
Stove Hinge
Holes
B
Figure 5.1
Locknut
Latch Cam
Figure 5.2
Square Key