Table of Contents
Advertisement
6
Appliance Set-Up
A. Leveling System
The leveling bolts are located at the rear of the appliance.
To access the bolts, remove the front access panels.
Reach in and turn the bolt to the desired height to level the
appliance.
Leveling Bolt on Each Side
Figure 19.1
Figure 19.2
October 23, 2018
B. Outside Air Kit Instructions
Parts Included in Kit: 1 piece of 2 inch x 3 ft. flex hose,
2 hose clamps, 1 collar assembly, 1 termination cap
assembly, 1 trim ring, fasteners.
Tools Needed: Phillips head screwdriver; wire cutters; hole
saw or jig saw.
1. Measure distance from floor to air vent opening in
2. Use saw to cut opening in wall. Cut a 2-1/2 to 3 inch
3. Use hose clamp to secure flex pipe to collar assembly.
4. Slide trim ring over flex pipe and run pipe through wall.
5. Attach hose to outside termination cap with second
6. Secure termination cap to outside surface.
7. Secure trim ring to interior wall.
Never draw outside combustion air from:
•
•
Attach Termination
Cap to Exterior Wall
2 inch diameter
Flex Pipe
7019-230J
appliance and mark location on wall.
(64-76mm) opening on inside wall and a 3 to 3-1/2 inch
(76-89mm) opening on outside of house.
hose clamp.
CAUTION
Wall, floor or ceiling cavity
Enclosed space such as an attic or garage
SANTA FE PELLET INSERT
19
Advertisement
Table of Contents
