Table of Contents
Advertisement
1
Important Safety Information
A. Appliance Certification
Model:
Adventure III
Laboratory:
Underwriter's Laboratories, Inc.
Report No:
MH 60687
Type:
Solid Fuel Room Heater
Standard:
UL1482-10 and ULC S627-00
and (UM) 84-HUD, Mobile Home
Approved.
NOTE: This installation must conform with local codes. In the
absence of local codes you must comply with the UL1482, (UM)
84-HUD and NPFA211 in the U.S.A. and the ULC S628-93
and CAN/CSA-B365 Installation Codes in Canada.
B. BTU & Efficiency Specifications
EPA Certification #: 1001-15
EPA Certified Emissions: 2.9 grams per hour
*LHV Tested Efficiency: 75.5%
**HHV Tested Efficiency: 70%
***EPA BTU Output: 11,200 to 43,300 / hr.
****Peak BTU/Hour Output: 98,100
Vent Size: 6 inches
Firebox Size: 4.5 cubic feet
Maximum Wood Length: 24 inches
Ideal Wood Length: 22 inches
* Weighted average LHV (Low Heating Value) efficiency using
Douglas Fir dimensional lumber and data collected during EPA
emission test. LHV assumes the moisture is already in a vapor
state so there is no loss in energy to vaporize.
**Weighted average HHV (High Heating Value) efficiency using
Douglas Fir dimensional lumber and data collected during EPA
emission test. HHV includes the energy required to vaporize the
water in the fuel.
***A range of BTU outputs based on EPA Default Efficiency and
the burn rates from the low and high EPA tests, using Douglas
Fir dimensional lumber.
****A peak BTU out of the appliance calculated using the max-
imum first hour burn rate from the High EPA Test and the BTU
content of cordwood (8600) times the efficiency.
The Quadra-Fire Adventure-III Series Wood Burning Appliance meets
the U.S. Environmental Protection Agency's crib wood emission limits for
wood heaters sold after May 15, 2015.
This appliance needs periodic inspection and repair for proper operation.
It is against federal regulations to operate this appliance in a manner
inconsistent with operating instructions in this manual.
C. Mobile Home Approved
This appliance is approved for mobile home installations
when not installed in a sleeping room and when an outside
combustion air inlet is provided. The structural integrity of
the mobile home floor, ceiling, and walls must be maintained.
The appliance must be properly grounded to the frame of the
Quadra-Fire • Adventure-III Installation Manual • 4083-901 • Rev B • 05/15
Fuel Seasoned Cord Wood
mobile home and use only listed double-wall connector pipe.
Outside Air Kit, part OAK-ADV must be installed in a mobile
home installation.
D. Glass Specifications
This appliance is equipped with 5mm ceramic glass.
Replace glass only with 5mm ceramic glass. Please contact
your dealer for replacement glass.
NOTE: This installation must conform with local codes. In the
absence of local codes you must comply with the UL1482, (UM)
84-HUD and NPFA211 in the U.S.A. and the ULC S627-00 and
CAN/CSA-B365 Installation Codes in Canada.
WARNING
Fire Risk.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be voided
by, the following actions:
•
Installation and use of any damaged appliance.
•
Modification of the appliance.
•
Installation other than as instructed by Hearth & Home
Technologies.
•
Installation and/or use of any component part not approved
by Hearth & Home Technologies.
•
Operating appliance without fully assembling all
components.
•
Do NOT Overfire - If appliance or chimney connector glows,
you are overfiring.
Any such action that may cause a fire hazard.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualified
installer, service agency or your dealer.
NOTE: Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products, their
specifications and/or price without notice.
Hearth & Home Technologies WILL NOT warranty appli-
ances that exhibit evidence of over-firing. Evidence of
over-firing includes, but is not limited to:
•
Warped air tubes, deteriorated refractory brick retain-
ers, deteriorated baffle and other interior components.
E. Non-Combustible Materials
Material which will not ignite and burn, composed of any
combination of the following:
- Steel
- Plaster
- Brick
- Iron
Materials reported as passing ASTM E 136, Standard
Test Method for Behavior of Metals, in a Vertical Tube
Furnace of 750° C.
F. Combustible Materials
Material made of/or surfaced with any of the following ma-
terials:
- Wood
- Compressed Paper
- Plant Fibers - Plastic
Any material that can ignite and burn: flame proofed or not,
plastered or un-plastered.
-Glass
-Concrete
-Slate
-Tile
-Plywood/OSB
-Sheet Rock (drywall)
3
Advertisement
Table of Contents
