Appliance Set-Up; Pedestal Assembly And Ash Removal System (Ars) Installation - Quadra-Fire 43M-ACC-MBK Installation Manual

4300 Wood Appliance Series ACC
5

Appliance Set-Up

A. Pedestal Assembly and Ash Removal
System (ARS) Installation
NOTE: The Ash Removal System, must be
installed first before installing the pedestal.
Included in Kit: ARS door assembly, ARS latch assembly,
Pedestal, Ash Pedestal Drawer, ARS Channel, ARS Cover,
and fastener package.
Tools Required: 7/16 socket wrench, 3/8 open end wrench,
phillips screw driver, and hammer.
Begin installing the ARS System.
1. Remove leg mount brackets packaged inside of firebox
and discard.
2. Remove the 2 bricks in the front most part of the firebox
(Figure 18.1).
3. Lay appliance on its back on a protective pad or pallet
(Figure 18.2).
4. Remove heat shield by loosening the four bolts using 3/8
open end wrench (Figure 18.2).
5. Remove 8 nuts that hold the cover plate on using a 7/16
socket wrench; discard cover plate (Figure 18.2).
Warning!
CHECK GASKET!
• Verify that the gasket is present and that the glossy
side is away from firebox bottom.
• It is important that the gasket is put in correctly for
sealing capabilities.
6. Remove knock out from bottom of firebox by using a
hammer (Figure 18.2).
7. Install ash door assembly by sliding the rod at an angle
into the slot on the left side (Figure 18.3).
8. Slide the ash door over the 8 screws protruding from the
bottom of the appliance. Secure with nuts and washers
using 7/16 socket wrench (Figure 18.3).
9. Install ARS latch by sliding latch assembly over 2 threaded
studs protruding from the bottom on the left hand side of
the appliance. Secure by using two nuts use 7/16 socket
wrench (Figure 19.1 on page 19).
10.Add knob to handle rod (Figure 19.2 on page 19).
11.Using two bolts and two flange nuts to secure ARS chan-
nel using 3/8 open end wrench and 7/16 socket wrench
(Figure 19.3 on page 19).
18
Do NOT operate before fully assembling components.
Burning your stove without a pedestal or leg kit
attached:
• Will void your warranty.
• May result in property damage or personal injury.
Figure 18.1
7
4
Remove
X4
Figure 18.2
Figure 18.3
7037-172
WARNING
2
2
Remove 2 bricks for
installation and then re-install
5
Remove
X8
Gasket
X
Cover Plate -
Remove
& discard
6 Knock out
5
& discard
Ash Door
Assembly
8 threaded
studs
Slot to slide rod of Ash
Door Assembly through
September 26, 2016
Remove
and discard
4
Heat Shield -
Remove
& discard