Function Setting - Mitsubishi Electric G-50A Instruction Book

5 - 3 Function setting

• The functions of this controller are set according to the function settings.
• The functions selects are set to OFF when the controller is shipped from the factory.
(1) Select "7.FUNCTION SETTING"(or
7
(2) Switch the function by pressing the function No. you want to change, or the
of the same number.
Each time the switch is pressed, the ON/OFF state of that No. is switched. (NO. 1 and NO. 2 cannot be changed.)
<Operation example>
1)When Input
3
3
ON
OFF OFF
BACK
(3) When the switch is pressed at the end of function switching, the screen returns.
SCREEN
MENU
6 ADDRESS SETTING
7 FUNCTION SETTING
8 IP ADDRESS SETTING
BACK
<Function selects>
No. 1
Reserved for future use (Leave this switch set to OFF)
No. 2
Reserved for future use (Leave this switch set to OFF)
No. 3
OFF : No K transmission converter installed
No. 4
OFF : Operation prohibit setting valid
No. 5
OFF : Emergency stop broadcast enabled (Be sure to use)
No. 6
External input changeover (refer to section "7 External input/output function")
No. 7
No. 8 The range of a controller which the operation is prohibited
OFF : Both of the system controller and the local remote controller
switch was pressed.
3
ON : Active
WED 15:29
"2. FUNCTION SETTING").
2
Press the switch
7
to select"7FUNCTION
SELECT"
BACK
Press the
SCREEN
switch to go back
to the initial
setting menu.
-26-
to
1 8
FUNCTION SETTING
1 2 3 4 5 6 7 8
ON
OFF
ON : K transmission converter installed
ON : Operation prohibit setting invalid
ON : Emergency stop broadcast disabled
ON : Only the local remote controller
switch