Mitsubishi Electric G-50A Instruction Book page 32

NEXT
NOTE:
When this unit is set to slave system controller by No.2 function select, interlocked operation settings can-
not be adjusted. However monitoring of the contents of the interlocked operation settings is possible.
6
Used the numeric keypad switch to set the address of the indoor unit
that operates with displayed interlocked OA processing unit or LOSSNAY.
<Operation example>
When the indoor unit which address is 012.
1) Input "0"
2) Input "1" 01
3) Input "2"
012
4) Press the
*It is also possible just enter "1" "2" .
<When the input is incorrect>
Before pressing
switch, move the cursor to the address to be deleted and press
the switch to delete these addresses.
DEL.
7
Set all the indoor units that operate with displayed interlocked OA
processing unit or LOSSNAY.
8 Repeat operation to
5
eration units managed by this controller.
9 When all settings are completed, press the
Initial setting screen is displayed.
This ends the interlocked operation setting.
When the interlocked operation settings are performed, refer to section
"5-5 Interlocked operation setting" .
When the group name settings are performed, refer to section "5-6 group
name setting" .
When the user setting are performed, refer to section "5-7 user setting" .
Simultaneously press the
for 2 seconds to complete user operation.After the initial setting processing
is completed (The initial setting screen will be displayed), refer to section
"4 User operation ( page 10 )" and perform user operation.
-30-
0
switch 012
switch, continue to input the data. After pressing
to set the indoor units of all interlocked op-
7
BACK
SCREEN
and keys on the initial setting menu screen
switch.